Troubleshooting Puraclenz Core
      Back to home
      1. Knowledge Base
      2. Installation & Troubleshooting FAQs
      3. Troubleshooting Puraclenz Core

      Parts Replacement Instructions for Puraclenz Core™ 750

      How do I replace the Core 750 Filter? How do I replace the Recharge Cell™? How do I replace the Core 750 Lamp?  

      Replacement Instructions

      NOTE: You must always unplug your purifier before cleaning or replacing parts.

      Core 750 Filter replacement is quick and easy.

      Core - remove housing

      1. Ensure your unit is off and unplugged.
      2. Locate the lock on the base of your unit and slide the lock mechanism to the left.
      3. Lift the top of the unit off by grasping the Top Rim and sliding it upward.
      4. Remove the dirty filter and replace it with a new filter.
      5. Replace the top of the unit and slide the lock back to the right.
      6. Finally, press the filter button on the top of the unit for 5 seconds to reset the filter timer.
      7. The yellow or red light will turn off, indicating the filter timer has been reset.

       

      Core 750 Lamp is simple to replace.

      Core - replace UV lamp

      1. Ensure your unit is off and unplugged.
      2. Locate the lock on the base of your unit and slide the lock mechanism to the left.
      3. Lift the top of the unit off by grasping the Top Rim and sliding it upward.
      4. Remove the filter.
      5. Remove the black UV housing.
      6. Remove the old lamp by pulling up on the base of the lamp.
      7. Recycle the old lamp by following your local municipality’s guidelines.
        NOTE: Take care to only hold the white portion of your new UV lamp. Never touch its glass tube.
      8. Place the new UV Lamp back into the socket by carefully aligning the pins to the socket on the unit.
      9. Reinstall the black UV housing and filter.
      10. Replace the top of the unit and slide the lock back to the right side.
      11. The UV Lamp indicator light at the top of the unit turns off when you have successfully installed your new UC Lamp.

       

      Recharge Cell™ can be replaced in seconds.

      Core - replace Recharge Cell

      1. Simply twist and remove the old Top Cover.
      2. Remove and discard the retention clip on top of the Recharge Cell by squeezing inward.
      3. Note: Some models may not include a retention clip.
      4. Remove the old Recharge Cell by sliding it out from the Purifier and discard.
      5. Slide in the new Recharge Cell into the Purifier unit by aligning keyholes.
      6. Then install the new Top Cover provided.
      7. You’ll know it’s working when the green light turns on.